35
36
3) Motor test
- For the motor operations (6 steps), the average current (Aa) and the peak cur-
rent (Ap) can be selected, using either 4.8V or 7.2V.
Test voltage setup. (4.8V or 7.2V)
Displays the average current and the peak current for
6 steps.
Each step is operated using 5sec on/ 3sec off.
Setting the number of cycles (1-10 cycles)
Setting the operating voltage, the operating time, and the
delay time, for each of the 4 steps.
The operating cycle number.
Warmer setup
Connect the warmer to the 4mm banana charge socket. Tap the WARMER icon to access
the warmer setup mode. This page has 2 menus.
1) Battery Warmer
- At low temperatures, lithium type batteries tend not to perform well. This function is used
to warm up the batteries to ensure proper function for batteries stored outdoors. Connect the
exclusive battery warmer bag to the charger output terminal and the temperature sensor connector.
Then, program the required parameters.
2) Tire Warmer
- This feature can be used to warm rubber tires, providing an important competitive edge on the
track. Connect the tire cup to the charger output terminal and to the temperature connector.
Then, program the required parameters.
Temperature setup
Alarm setup
Alarm rings at the preset time. The charger continue oper-
ating. Tap the STOP button to stop the alarm.
Output voltage setup
With an installed temperature sensor, this function is con-
trolled automatically. The preset voltage can be outputted
for operations without a temperature sensor.
The temperature setup range is 5-15V
Processing time and temperature
With bags that can not accommodate a temperature sensor, the temperature can not
be controlled automatically. To ensure a proper temperature, control the voltage to
maintain the desired temperature inside the bag. Caution is warrented as an over
voltage setup can cause fires.
