IS400 machine
. 20
First contact
Switching the machine on
Switch on the machine (switch to position I).
When switched on the ventilator of the machine will start.
The following message will be displayed on the L.C.D. screen of the machine :
Boot Program X.X
RAM: 2M
The machine will then emit a "beep" and a new message will be displayed :
<< GRAVOGRAPH >>
VERSION XX.XX
Leave the machine plugged in even if it is not in constant use.
Problems
If one of the operationan signs is absent, check the following points :
• Are the twoo ends of the mains cable correctly connected ?
• Is the mains plug connected ? Is it live ?
If the machine does not come on, before calling a technician, please check power
connections to the mains socket.
Switching the machine off
Switch the switch ON/OFF (I) to position 0.
Switch off the machine for the following reasons :
- if you are leaving the workstation (end of the day, for example),
- physical damage (fall, fire, liquids coming into machine…),
- mechanical/electrical/electronic faults, leading to a possible breakdown,
- in case of major problem or mechanical block of the machine,
- to reboot,
- for external cleaning.
Mechanical block
In the following cases :
- danger for the operator,
- block on the support to be engraved,
- block on an object placed in the work area,
1.
Cut the power supply by switching the switch ON/OFF (I) to position 0.
2.
Free the tool, without switching the machine on, by manually and slowly moving the tool holder
as required.
3.
Only switch the machine back on after ensuring that the tool's moving area is totally clear.
Switching on again
If the machine or the programme which runs it crashes you may have to reboot the machine.
If this happens, switch the machine off. Wait 30 seconds and switch it on again.
You must wait for 30 seconds. This time allows any electric shock to the machine,
possibly damaging the power supply, to be avoided.
