IS400 machine
. 30
First contact
Setting-up the spindle origin
17. Save the position of the spindle by pressing
The spindle moves up.
Adjusting the tool depth
18. Turn the index finger a few notches to the right to obtain the desired engraving depth (one notch
= 0.025 mm) (diagram 35).
Refer to the table opposite for the number of marks to move the index finger depending on the desired depth and the material
used.
19. Tighten the index finger in order to maintain the scaled knob in this position.
20. Close the belt housing of the tool-holder.
To avoid any risks of getting burnt, the protective belt housing of the tool-holder must
be always closed, except when carrying out adjustments.
0
5
Anodisal
Silver
Chrome
Gravometal
Gravoply II
Stainless Steel
Brass
Metallex
Gold
Plastic
Engraving
material
Carbide
Carbide
Diamond
Carbide
Carbide
Diamond
Carbide
Carbide
Carbide
Carbide
Type of cutter
0,1
0,3
0,025
0,1
0,1
0,2
0,2
0,1
0,3
0,2
Engraving depth
in mm
4
12
1
4
4
8
8
4
12
8
Number of
marks
