IS400 machine
. 32
First contact
Starting to engrave
This sign shown on the spindle of the machine shows the danger caused by the
rotating spindle during engraving (risks of getting burnt or cut).
To avoid any risks of getting burnt, the belt housing of the tool-holder must be always
closed except for when adjusting the tool-holder and changing the spindle belt.
For your own personal safety and to avoid any risks of being crushed by the machine
during engraving, do not stand near the tools or lean over the spindle holder (the travel
area of the tool is 305 x 210mm).
Always wear protective glasses againts chip ejection.
Before starting the engraving, ensure that the spindle travel area is completely clear.
Ensure that no one is in the travelling area of the moving parts of the machine and that
no object will obstruct the travelling of the moving parts.
22. Press START (Engraving Start)
The tool holder moves over to the first point on the engraving and starts to engrave.
To stop engraving (if there is a problem), press PAUSE
The machine will pause.
To continue engraving, press START (Engraving Start)
To stop engraving completely, press one of the arrows on the joystick.
To increase the travel speed of the spindle during engraving,
press the arrow
To reduce the travel speed of the spindle during engraving,
press the arrow
