First contact
L-SOLUTION 100 Ex Fibre machine
. 17
Exhaust system installation recommendations
To properly exhaust fumes and smoke from the LASER engraving system during operation, you must have a proper
exhaust system.
The air exhaust system MUST comply with the following
minimum
requirements :
Never operate the LASER engraving system without a properly installed and operating
exhaust system. When cut or engraved, some materials can produce fumes that are
hazardous in concentrated amounts.
To install the exhaust system properly, we recommend having the exhaust system installed by a licensed contractor
compliant with safety and local code requirements as well as being able to calculate the correct size blower required for
your particular installation.
The fume exhaust to the air exhaust system goes through the tube connected on the rear side of the LASER machine
(pict. 3)
.
Installation
MIN. RECOMMENDED EXTRACTOR CHARACTERISTICS
General mode
With
Preseparator
Max. air throughput
m
3
/h
> 200
> 300
yard
3
/min
> 4.36
> 6.54
Max. vacuum
kPa
> 0.5
> 6
PSI
> 0.07
> 0.87
Outlet diameter
mm
100
100
in
4
4
Air-assist requirements (compressor optional)
In order to use the Air-assist system (air seal), you should use an air compressor
(optional accessory, not delivered that has the following characteristics:
- Air draught min.
=
0.0157 yard
3
/mn or 3.1 US gallon/mn
(12
l/mn)
