L-SOLUTION 100 Ex Fibre machine
. 22
First contact
MPowering the machine on
Switch on the machine (main stop button (L) to I position).
The following message will be displayed on the L.C.D. screen of the machine :
SET UP
FPGA X.XX
INIT LASER FIBRE ...
SET UP
The machine will then issue a "beep" and a new message will be displayed :
<< GRAVOGRAPH >>
FPGA
X.XX
LCD
SOFT
X.XX
32 Mo
BOOT X.XX
Leave the machine plugged in even if it is not in constant use.
Problems
If one of the operational signs is missing, check the following points :
• Are both ends of the mains cable connected correctly ?
• Is the mains plug connected ? Is it live ?
If the machine does not come on, before calling a technician, please check power connections
to the mains socket.
Powering the machine off
Switch the main stop button (L) to the 0 position.
Switch the machine off in the following cases :
- if you are leaving the workstation (e.g. at the end of the day),
- physical damage (fall, fire, liquids coming into machine, etc.),
- mechanical/electrical/electronic faults, leading to a possible breakdown,
- in case of a major problem or a mechanical jamming of the machine,
- to reboot,
- for external cleaning.
Mechanical jamming
In the following cases :
- the medium to be engraved is jammed,
- an object placed in the work area is causing a jam,
Powering on again
If the machine or the programme which runs it crashes you may have to reboot the machine.
If this happens, switch the machine off. Wait 30 seconds and switch it on again.
You must wait 30 seconds. This delay helps avoid any electric shock to the machine likely
to damage the power supply.
Installation
This phase of initiation (30s mini.) is
necessary. She allows the LASER to
reach her optimal temperature and to
be stable.
