First contact
L-SOLUTION 100 Ex Fibre machine
. 37
"Blocks in Y and X" Mode :
The engraving software determine automatically several
engraving blocks (blocks #1,#2, #3, #4, #5 and #6,),
in Y then in X, from the graphics and the text to be
engraved on the plate :
The engraving begins in the upper left corner
(point D1) of the block (block #1) in the upper left
corner of the plate. The engraving of the block is made
from left to right and from right to left. The engraving
of blocks succeeds one another in the order 1,2,3,4,5,6.
The engraving ends with the last block (#6) in the lower
right corner of the plate.
The engraving begins in the upper left corner (point
D1) of the block (block #1) in the upper left corner of the
plate. The engraving of the block is made only from left
to right. The engraving of blocks succeeds one another
in the order 1,2,3,4,5,6. The engraving ends with the
last block (#6) in the lower right corner of the plate.
The engraving begins in the lower left corner
(point S4) of the block (block #4) in the lower left
corner of the plate. The engraving of the block is made
from left to right and from right to left. The engraving
of blocks succeeds one another in the order 4,5,6,1,2,3.
The engraving ends with the last block (#3) in the upper
right corner of the plate.
The engraving begins in the lower left corner (point
S4) of the block (block #4) in the lower left corner of the
plate. The engraving of the block is made only from left
to right. The engraving of blocks succeeds one another
in the order 4,5,6,1,2,3. The engraving ends with the
last block (#3) in the upper right corner of the plate.
Engraving
Engraving
Printer driver
Displacement without
engraving
Displacement without
engraving
