L-SOLUTION 100 Ex Fibre machine
. 38
First contact
Graphics
The following paragraphs propose you a brief description of the various available graphic modes. They allow on one hand
to have different engraving result and on the other hand to acquire parameters for the black color or for all the colors.
Printer driver
« Automatic »
is used to run the printing to convert the colours
in the cliparts and texts to levels of grey so
that it can automatically assign the adequate
power to each pixel based on the level of grey
and proportional to the power assigned to the
colour black.
Engraving of the entire job is done in one scan.
The engraving parameters (max power, speed
etc.) are set by the colour black.
« Filling »
is used to process the colours in the same way
as the automatic mode. For each of these levels
a specific filling is applied.
The engraving parameters (max power, speed
etc.) are set by the colour black.
All the points are engraved with the same
power (set by the colour black).
Engraving of the entire job is done in one scan.
« User colours »
is used to run the printing to convert the
colours from 8 basic colours set in the
print drive interface. The other colours are
converted to the closest colour of these 8.
Engraving of each colour block is done
separately with its associated engraving
parameters.
The colours in the photos (bitmap format) are
processed like in automatic mode. Engraving
of the photo block is effected after the last
colour block with engraving parameters of the
colour black.
« Negative image »
used to run printing to convert an image into
its negative image. All the objects which were
filled with black and thus engraved become
images filled with white and no longer engraved
.
« Photo mode »
Each obtained dot will be engraved with the
same power (the power of the black color).
The optical illusion of shades of grays appears
due to the density of these dots. Therefore the
result will be the same whatever the material
you use.
