First contact
L-SOLUTION 100 Ex Fibre machine
. 53
System operation
Motion System
The motion system consists of the mechanically moving parts of the LASER system. It is made up of rails, motors, bearings,
belts, mirrors, a lens, and other parts. There are two directions of motion, left to right is called the «X» direction and
front to back is called the «Y» direction.
The PUI and the UC boards control the movement of the motors, which moves the mirrors and focus lens across the
engraving area and over the material. At the same time, it is synchronizing the LASER pulses with the position of the
focus lens.
It is this precise positioning and timing of the LASER pulses that produces the highest quality and fastest speed of engraving.
To sum up, the six components work together to take the graphic image that is downloaded to the LASER system from
your computer and burn it into the material located on the engraving table inside of the LASER system.
The control panel
(diagram 1)
Air Assist
Positioning red diode
Following File selection
Exhaust system
Autofocus
Previous File selection
Start - Engraving start
Pause
Cancel
Validation
Focus adjustment
AIR ASSIST
ADJUSTMENT
INDICATOR LIGHT
JOYSTICK
