L-SOLUTION 100 Ex Fibre machine
. 84
First contact
12. Before you continue, you must imperatively remove the wedge
Do not forget to remove the wedge
a this time of the procedure.
Otherwise, it can severely damage the LASER machine.
13. Close the door of the LASER machine
14. Validate by remaining pressed on the key
until the Autofocus begins.
RE-ALIGN X-Y
RE-ALIGN Z
ALIGNMENT MODE
15. Exit the RE-ALIGN MACHINE menu using the key
SET LASER TYPE
TICKLE
RE-ALIGN MACHINE
UTILISATION
XXX
16. Exit the MACHINE menu using the key
The following screen will remain displayed for 3 seconds:
<< GRAVOGRAPH >>
FPGA
X.XX
LCD
SOFT
X.XX
32 Mo
BOOT X.XX
The following message will be displayed. It indicates that the LASER machine is ready to receive files:
<READY TO RECEIVE>
Do not use the controls or settings and do not carry out procedures other than those
specified in the use manual, to avoid risking exposure to dangerous radiation.
Autofocus adjustment
