GRE Evolution AR208201, Operating Instructions Manual

Dear Customer,
Thank you for choosing our product to clean your pool. We hope
that you will enjoy using your new robot to maintain your swimming 
pool for years to come.
Before you begin to use your robot, please take a few minutes to 
carefully read these operating instructions.
Again, thank you for choosing our product.

1

IMPORTANT

CAUTION: Do not switch the pool cleaner “ON” if it is not fully 
immersed in water. Operating the cleaner out of water will 
cause severe damage immediately and will result in loss of 
warranty.

Allow the cleaner to remain in the pool for 15 to 20 minutes 
following the end of its cleaning cycle. This will allow the 
motors to cool adequately. Do not leave the cleaner in the 
pool all the time. Always remember to turn the power supply 
“OFF” and unplug it from the power outlet before removing 
the cleaner from the pool.

WARNING: Your Cleaner should not be used while people 
are swimming in the pool.

Safety Note

- The unit must be supplied through a residual current device 
(RCD) having a rated residual operating current not 
exceeding 30 mA 
- The connection to the branch circuit should be consistent 
with the local and national wiring rules (electrical code).
- Mishandling of the unit can result in leakage of lubricants. 
- If the supply cord is damaged, it must be replaced by the 
manufacturer’s service agent or a qualified and trained 
person in order to avoid hazards. 

ENGLISH