a) Check to see if forward/reverse motion is obstructed by
foreign matter; hair, debris, etc. on drive belts (6) or drive
tracks (7) or there is an entanglement with the power cord.
Clean as necessary.
b) Check if drive belts (6) have slipped out of place. Also
check for proper tension of drive belts (6). If necessary
replace belts.
c) Check for loose drive motor (3) connections.
d) If a, b, and c are negative, check the Master and Slave
motors. If one or the other is not functioning, send the unit
to your service center.
a) Check
2a
and
2b
of this guide.
b) Check the Intake Valve Flaps (23) on the underside of your
unit. The Flaps should move freely to open and close.
Clean and free the Valve Flaps (23) if necessary.
3. Unit does not move but does pump water:
4. Unit does not pick up dirt and debris:
5. Unit does not seem to cover the entire pool:
a) Most likely a thorough cleaning of the filter bag (12) is
needed.
b) Check to see that the blue cable (15) is properly spread
out and is untangled.
c) Allow the unit to run in the pool for the entire cleaning
cycle.
d)
Make sure that the Floating Handle (14) is locked
diagonally across the top of your unit's body.
e) Check that the Pump Motor
(2) is operating. Please refer
to the Troubleshooting section titled
“Moves But Does
Not Pick Up Dirt And Debris”
f) After following all of the above, if there is still a problem,
call your dealer for specific additional assistance.
8
Summary of Contents for Evolution AR208201
Page 1: ......
