Jaguar II User Manual
Installation and Operation of Sign Cutting Plotter 2-12
4.
Then turn the roll downward to make an equal tension across the media (
Figure 2-26
)
5.
Move the pinch rollers to the appraise location and please note that the pinch rollers must be
positioned above the grid drums.
6.
Push the lever backward to lower down the pinch rollers.
7.
Fixes roll media guide bushes on the roll holder to secure the roll media
8.
Turn on the power switch, the tool carriage will sizing the media automatically.
Then the cutting plotter is ready to work.
9.
Use the reverse steps to remove the media.
Note :
Make sure that the media
tension is equally distributed
from left to right. If the media
were not tighten enough
against the platen, it would
cause tracking problems!
Figure 2-26
