Jaguar II User Manual
Set Panel Setup
Setting to “Accept setup command”, the cutter
receives changes of set up commands from the
software when the machine is disabled.
Setting to “Control panel only”, the cutter will not
accept any set up command from the software,
the Force, Speed, Cutting Quality, and Offset
must directly changed from the Control Panel of
the cutter.
Save Parameter It can save 4 patterns of cutting parameters for
later use.
Save 1 to 4
Pattern 1
Over Cut
It will cut an excess margin from the first and last
line segments.
0.00mm-1.00mm
0.05mm/step
0.00mm
Restore default It returns the settings values of the menu items
to factory-default values.
-
Square Cut
This performs a cutting test at the present blade
position.
For more information, please refer to 2-7
adjusting the blade force and cutting speed.
Recut / Copy
Allows user to repeat the last job without
sending the file again.
Setting Range:
For Recut: 1-99 with an increment of 1.
For Copy: 1-99 with an increment of 1.
It will leave 1mm between each copy.
Note: If the media is not large enough to
continuous copy, it will shows as following.
O
p
O
t
u
S
f
a
;
c e
#
i
C
f
o
p
o
e
i
s
f
n
h
i s
e d
If both functions are selected at the same time,
the cutter only executes the last setting.
[Cut Test]
Mark Positions
(for contour
cutting)
This feature is making contour cutting on the
images that were generated by printers. The
registration marks should be printed along the
border of the image. Jaguar II provides two
alternatives.
1. 2-points registration contour cutting
2. 3-points registration contour cutting
Description of Operation 3-7
