9
STEP 10:
Insert 4x cam dowels (#1) into BOTH of the
base unit side panels G & H.
STEP 11:
Take the K/L base panel and
insert 4x wooden dowels into the
remaining holes in the corner.
Position back support panel N first,
it needs to be flat on the floor. The
large drill holes on the panel to be
facing the floor and the small pilot
holes on the edge MUST be facing
outwards by the corner. Push onto
the the dowels of K/L.
Now take back support panel M and position with the drill holes facing outwards.
Push onto the dowels of K/L and insert 1x cam lock into the hole that can be seen
and turn clockwise to lock.
Take the I/J top panel and insert 4x wooden dowels into the remaining holes in the
corner.
Now push this onto the back support panels N & M.
Insert 1x cam lock in the large hole on panel M and turn clockwise to lock.
NOTE: The cam locks on panel N will be secured at a later stage.
Hardware for Step 10:
8x #1 Cam Dowels
#1
#2
#3
G
K
L
I
J
H
Hardware for Step 11:
2x #3 Cam Locks
BASE
TOP
It is important that these
small pilot holes are visible
and in this position on panel
N, as they are needed in a
later step.
N
M
#1
#1
#1
#1
#1
#1
#1
#1
#3
#3
#2
#2
x4
x4
8x #2 Wooden Dowels
