2019-06-12
401-705M
YP3025A
179
Appendix R - Row-Pro™
Preparation and Setup
Row-Pro™ Setup (Option)
The factory default setting for down-force is likely to differ
from that required by your next field conditions.
Before modifying the monitor setting for down-force,
determine what actual down force is ideal for the initial
use of the planter. One method of determining an initial
setting involves operating in the field (without seeding).
1. Set planting depth at T-handles (page 73).
2. Review unit-mount coulter depth relative to opener
disc. Adjust as needed (page 71).
3. Start with the row unit down pressure springs in the
lowest, or second-lowest notch (page 69).
Adjustment to the spring pressure may need to be
made if the depth is reset or the closing wheel down
pressure is adjusted.
4. Operate
a
in the field for a short distance.
5. Evaluate the seed trench (page 68).
6. Adjust the springs until depth and closure are ideal. If
the ideal setting seems to be in between two notch
values, use the higher setting. Rows in wheel tracks
may be higher still.
7. Engage the Row-Pro™ system. Set the initial target
weight at 80 pounds.
8. Operate in the field. Evaluate furrow and closing.
Adjust Row-Pro™ force setting for optimal results.
9. When verifying the final setting, and when planting,
watch for Unable to Control alarms, which may
indicate that the cams are a notch or more too high
or too low.
If the IntelliAg
®
alarm indicates a value too high,
reduce spring pressure. If the IntelliAg
®
alarm
indicates a value too low, increase spring pressure.
The actual target rate is going to be different depending
on the field conditions, soil type and other factors. The
best way to gauge where you want the setting is to
operate the system for a short time then go behind the
planter and check the furrow.
a. Optionally operate the Row-Pro™ system in Monitor Only mode, and note the forces reported.
36544
36545
