YP3025A
Operating Instructions
35
2019-06-12
401-705M
Transport Checklist
Plan the route. If towing a cart hitched to the Planter,
plan the route so that no reverse movements will be
necessary. Avoid steep hills. Keep Clearances in
mind. Folded, your YP3025A Planter may be nearly
15 feet (4.6 m) wide and 13 feet (4 m) high.
Hitch.
Make both electrical and hydraulic connections. See
If markers are unfolded, fold them.
Raise Planter.
Install lock-up channels on lift cylinders.
Disengage caster locks. See page 32.
Fold and latch lower ladder section. See page 35.
If Planter wings are unfolded, fold them.
Make sure wing locks are engaged.
3-point hitch:
Lower hitch fully to ensure wings remain locked.
Hydraulic hitch:
Confirm CFM set to Hitch and hitch circuit in Float.
Always have lights on for highway operation.
Comply with all federal, state and local safety laws
when traveling on public roads.
Travel with caution.
Loading Materials
Walkboard and Ladder
Walkboard pin and pivot operation is covered on
The bottom two steps
of the walkboard ladder are a
swing-down section. To release it, pull the spring-loaded
pin
forward and pull the top of the free end of the
ladder back.
To re-stow the steps, merely swing them up and forward.
The spring-load pin automatically engages.
Machine Damage Risk:
Ladder steps must be locked up before lowering Planter or
machine damage will occur.
Figure 34
Walkboard Lower Ladder
31546
2
1
