2019-06-12
401-705M
YP3025A
Appendix R - Row-Pro™
182
Row-Pro™ Air Compressor System
Row-Pro™ Air Compressor
The 12VDC compressor requires both an electrical
connection and a mounting location. It should be
mounted in a location on the tractor or planter where
most convenient. Mount where cool clean air can get to
it. The battery connection is equipped with one large
60 amp spade fuse (automotive type).
If your tractor has an on-board engine driven
compressor capable of 150 psi, it can be used
instead of the one supplied with the planter. Hook
the on-board compressor to the air tank with lines
provided.
The air filter should be placed in the tractor cab where it
can pull clean air from the cab.The remote air filter line
should be as short as possible.
The air compressor pressurizes the air tank reservoir.
Row-Pro™ Air Tank
An air tank is provided and mounted on the wing. Open
the air tank petcock once daily to drain water
accumulation.
The air tank is used in conjunction with the air valves to
maintain a set pressure value for the air cylinders.
Air valves are used to increase or decrease the amount
of air provided to the air cylinders.
Row-Pro™ Air Tank Lines
The air tank has two lines. A
3
/
8
inch line attaches the
compressor to the air tank . A
1
/
4
inch line splits at a
T-junction
and goes to the valves while the
remaining end attaches to the compressor plate where
it activates the pressure switches.
If an on-board compressor is used, plug/bypass the
pressure switch branch.
Figure 163
Row-Pro™ Compressor
32087
1
Figure 164
Row-Pro™ Air Tank
32086
2
Figure 165
Air Tank Lines
32090
3
4
5
6
e
8
