2019-06-12
401-705M
YP3025A
Preparation and Setup
18
Protecting Fan Hydraulic Motor Seals
Low Pressure (Case) Drain Connection
1. Attach case drain hose to low pressure drain
connection.
Case drain hose has the smaller
1
/
4
inch I.D. hose
and small, flat-face, connector.
2. Connect low pressure motor return hose to low
pressure return connector. It is distinguished by a
large (1.06 inch/2.7 cm diameter) quick coupler.
3. Connect hydraulic hoses to tractor remotes.
Electrical Hookup
Make sure tractor is shut down with accessory power off
before making connections.
1. Mate lighting connector to tractor outlet.
2. Mate monitor connector to tractor harness.
3. Mate any optional or aftermarket electrical
connectors.
Make connections prior to Planter movement. Some
Planter hydraulic circuits are under monitor control.
Hitching with 3-Point
1. If the Planter is model YP3025A-2415 (“Even Row
15 inch”), check the configuration of the hitch offset
at “
2. Connect your tractor 3-point to the Planter 3-point
hitch. If using quick hitch be sure Planter locks into
hitch securely.
3. Raise tractor 3-point enough to relieve pressure from
parking stands.
Load Sway Hazard:
Adjust 3-point hitch arms and sway blocks to minimize any
side-to-side sway to assure proper tracking in the field, and
safe road travel.
Machine Damage Risk:
Case Drain Hose must be attached first,
prior to inlet and return hoses being connected.
Case Drain Hose must be detached last,
to prevent damage to the fan motor.
Machine Damage Risk:
DO NOT connect the case drain line to a
power-beyond-port.
Figure 6
Connector Identification
25236
25237
Figure 7
3-Point Hitch
29242