2019-06-12
401-705M
YP3025A
Preparation and Setup
20
Parking Stands
Store Main Parking Stand
1. Raise the tractor hitch slightly to lift parking stands
off ground.
2. Remove the lower pin
and the upper pin
holding the parking stand
.
3. Move the stand from under the tongue to an inverted
position in the bracket
on the left side on the
tongue. Pin in place.
Storing 3-Point Parking Stands
Refer to Figure 11 (shown without tractor for clarity)
1. For the standard 3-point hitch, store the two forward
stands by either of the following methods:
•
Remove the top pin , swing the stand out, up
and vertical around the bottom pin , and re-insert
the top pin , or
•
Remove the bottom pin , swing the stand inward,
to a horizontal positional under the hitch, and insert
the removed pin at hole
under the stand.
2. Adjust the top link of a 3-point long enough so the
ball swivel
does not bottom out when fully raised.
3. Secure hoses so they do not get caught in ball
swivel
. Failure to do so could cause hose to be
crushed requiring hose replacement.
Tank Cart Hitching
If using a fertilizer cart,
consult the cart manual
for:
•
hitching cart tongue to Planter
•
connecting pump control electronics to Planter
•
connecting fertilizer feed hoses to Planter
Complete the tractor-Planter hook-up before making any
tank cart connections.
Material Loss Risk:
Open hose and inlet valves when ready to begin planting.
Close them when not in use. Damage to hoses when not
applying material can result in rapid tank depletion.
Figure 10
Main Parking Stand Stored
29242
2
1
3
4
5
Figure 11
Storing 3-Point Stands
26034
7
9
8
6
Figure 12
Fertilizer Cart Connections
29269
L
C
R
S
G
