2019-06-12
401-705M
YP3025A
Operating Instructions
54
Caster Locks - Field Operations
For planting in conditions ranging from flat ground to
moderate slopes, the caster locks may be left in the
ROAD position, allowing the casters to pivot freely, and
simplifying fold/unfold operations.
For planting across extreme hillsides, where side drift
might occur, lock the casters after unfolding:
1. Move the lock handle
from ROAD to FIELD at
each caster.
The lock arm
will automatically capture and hold the
pivot plate detent
when the Planter next moves.
See page 32 for unlocking steps.
Hydraulic Planter Drive Checklist
Page
Check chain lubrication and slack
Input initial values for desired population
Pre-run system using manual ground speed
mode on seed monitor. Reset to digital
frequency source after test running.
Calibrate radar speed sensor pulses with
Planter lowered.
Lubricate slider joints on drive shafts
Confirm Clutch Folding Module Master switch
off, and check hydraulic Planter drive rotation
with 5 Rev Test.
c
a.
Refer to seed monitor manual and Seed Rate manual.
b.
Refer to seed monitor manual.
c.
See DICKEY-john
®
Planter/Drill Control manuals for 5 Rev Test
Meters Checklist
Page
Correct disks for seed
Corn?
Check timing of meters for twin-row
Check chain tension. Re-connect any loose
idler tensioning springs.
-
a.
Refer to Seed Rate manual.
1
3
2
Figure 57
Caster Lock
29306
