YP3025A
Adjustments
79
2019-06-12
401-705M
Removing a Seed Disk
1. Remove rain cover. If seed is present, close
shutter
to prevent more seed from entering meter.
Attach funnel (page 99).
2. Hold seed disk in meter. Rotate disk clamp
counterclockwise 45
to release disk.
3. Tilting top of disk toward meter, slowly remove disk,
allowing seed to collect in funnel. Open shutter to
release remaining seed up to wing tube.
4. Clean seed from all brushes. Clean disk seat ( in
page 78), so that new disks can seat fully.
Inspect brushes for excess wear and damage. See
5. Inspect removed disks for excess wear and damage.
Set aside any disks requiring replacement. Clean
other removed disks and place in storage. See
6. Re-install the rain cover (page 76).
Sprocket Indexing (Stagger)
If you are planting:
• twin-row crops,
• at seed interval spacings above 6
3
/
8
inch (16.5 cm),
you can synchronize each pair of adjacent meters in a
twin row so that you achieve the maximum seed-to-seed
spacing between the units of the pair.
Refer to the Seed Rate manual for details.
3
Figure 97
Remove Disk
29611
28420
