12
❏
6. Plug the flap servo into the flap channel or the decoder
hub into the S.Bus port on your receiver. Switch on your radio
system and adjust the flap control so that the travel is at its
end point. Install a servo arm on the flap servo so that it is
approximately 45 degrees from the centerline of the servo.
❏
7. Install the flap control horn following the same procedure
used to install the aileron control horn.
❏
8. Install the flap servo in the right wing half. Note that the
servo arm is on the wing root side of the servo.
❏
9. Use epoxy to glue the two 10 x 35mm hardwood wing
dowels in the wing.
❏
10. Use epoxy to glue the 8 x 35mm hardwood wing joiner
dowel 18mm into the left wing root.
❏
11. Trim the covering from over the exit holes and route
the aileron and flap servo leads, S.Bus decoder, or hubs
out the holes.
