25
❏
15. Assemble the throttle pushrod.
❏
16. Cut the outer pushrod tube 7-1/2" [190 mm] long.
❏
17. Roughen the outer pushrod with sandpaper.
❏
18. Install the outer pushrod.
❏
19. Assemble the throttle clevis.
❏
20. Install the nylon clevis on the throttle servo.
❏
21. Snap the pivot ball socket on the throttle pivot ball.
Switch on the radio system, and move the throttle stick to
full throttle. Rotate the throttle arm to full throttle.
❏
22. Slide the plywood outer pushrod support onto the
outer pushrod.
❏
23. Thread the throttle clevis into the throttle pushrod. Glue
the pushrod support to the fuselage. Adjust the throttle so
that it opens fully. We set up the throttle so that at low throttle
stick position the engine is at idle. We then set the throttle
cut on a switch to fully close the throttle and stop the engine.
