❏
6. Connect the correct fuel line to the carberator and the
fuel line plug to the fill line. The pressure line will be
connected to the muffler once the cowl has been installed.
❏
7. Use a #64 rubber band to secure the aft end of the fuel
tank to the former.
❏
1. Our test samples required some weight in the nose to
balance at the forward CG. We recommend wrapping the
receiver battery in foam and positioning it on top of the fuel
tank. Use scrap sticks to hold the battery in place.
❏
2. Glue two of the 1/4" x 1/4" x 1-3/4" [6.4mm x 6.4mm x
44mm] hardwood sticks to the former at the front of the wing
saddle. The sticks should be flush with the two radio tray
mounting slots.
❏
3. Position the other two 1/4" x 1/4" x 1-3/4" [6.4mm x
6.4mm x 44mm] hardwood sticks flush with the aft edge of
the radio tray and protruding 3/8" [9.5mm] out each side.
Drill a 1/16" [1.6mm] pilot hole through the radio tray and
hardwood stick. Mount the sticks to the radio tray with #2 x
3/8" [9.5mm] sheet metal screws and #2 washers.
❏
4. Insert the radio tray in the former at the front of the
wing saddle. Carefully apply a drop of medium CA to the
hardwood sticks at the aft edge of the radio tray. Do not get
CA on the radio tray. Position the radio tray flush with the top
of the arms on the aft radio tray former. After the CA has
cured, remove the two screws in the radio tray and remove
the tray. Use thin CA to permanently glue the two hardwood
sticks to the former.
❏
5. Reinstall the radio tray and drill two 1/16" [1.6mm] pilot
holes at the front of the radio tray, through the tray and
hardwood sticks. Attach the tray to the sticks with two
#2 x 3/8" [9.5mm] sheet metal screws and #2 washers.
❏
6. Install the throttle servo into the servo opening. Drill
through the servo mounting holes with a 1/16" [1.6mm] drill
bit. Remove the servo from the servo opening. Install and then
remove a servo mounting screw into each of the holes you
have drilled. Apply a drop of thin CA into the holes to harden
the threads. Once the glue has cured, install the servo into the
servo opening using the hardware included with your servo.
Center the throttle stick on the transmitter and then center the
throttle servo trim. Install a servo arm as shown.
Install the Throttle Servo
16
