D 20. Cut the sheeting off flush w i t h former F4T and the
end of the stringers and use a sanding block to sand the top
of the sheeting flush with the top of the formers and
stringers. Be careful not sand any dips or valleys into it
or the top will not fit nicely.
D 23. Glue the 3/32" die-cut turtle deck face (FUN 1 F07)
in place on the front of F4T and sand it flush using a
sanding block pressed flat against the t u r t l e deck. Do not
round o f f the corners of the face because the canopy will
bull up against this piece. Also sand it flush with the face
of F4B.
D 21. Glue the 3/16" x 1-3/8" x 14-7/8" balsa turtle
deck top (FUN 1 Fl 5) in place making sure it is centered.
Cut off the ends and sand them flush with former F4T and
the end of the stringers.
D 24. Glue the 3/16" x 15/16" x 3" balsa hatch front
(FUN1F11) in place. Allow it to overlap former Fl
slightly (1/32" or less). Sand it flush with the fuse sides
and the front of Fl.
D 22. Use a razor plane to carefully "rough" carve the
turtle deck top and then sand it with a sanding block to
blend in with the sheeting.
D 25. Glue the 1/4" square x 2-5/8" basswood hatch
hold down block (FUN 1 Fl 7) to the front of former F2B.
Notice that the top of the hold down is slanted and not
flush with the top of the fuse sides.
15
Summary of Contents for FUN-ONE
Page 5: ...5...
