❏
4. Remove the covering from the control horn slot on the
left side of the rudder.
❏
5. Glue the rudder control into the slot with medium CA.
❏
6. The bottom of the horizontal stab has the large gap for
the elevator hinge. Place the stab upside-down on your work
bench. Mark the inside end of the right elevator 1/4" [5mm]
that is perpendicular to the elevator’s leading edge, and that
runs from behind the leading edge to the trailing of the stab.
Carefully trim the inner edge off the elevator as shown.
❏
7. Glue the elevator control horn in place with medium
CA. Note: The removed piece can be shaped and glued to
the other side of the control horn for appearance if you
desire, but it is not necessary.
❏
8. Center and align the TE of the stab with the TE of the
fuse. Pin the front center of the stab to the center of the fuse.
Note: Folding the elevator up makes aligning the TEs with
each other easier.
❏
9. Attach a string to the wing dowel and pull it back to the
left corner of the stab. Mark the string at that location on a
piece of tape. Move the end of the string to the other side of
the stab. Rotate the stab until both lengths are the same. Pin
the TE of the stab to the fuse.
7
