8
❏ ❏
12. Bend the pushrod 90° at the mark that you made.
Fit the pushrod to the servo arm and fasten it with a FasLink
pushrod retainer. Cut off the remaining pushrod so that at
least 1/4" [6.4mm] of pushrod remains.
❏
13. Repeat steps 2 through 12 to prepare the right wing.
❏
14. Glue a 6mm x 25mm wing dowel into the leading edge
of each wing so that the dowel protrudes out 1/4" [6.4mm]
as shown.
❏
15. Sand the surface of the wing alignment dowel to
prepare it for glue.
❏
16. Glue the 3mm x 20mm wing alignment dowel into the
left wing as shown so that at least 10mm is protruding.
Fixed Wing Flap (Option 1)
On this model, you can set up the flaps one of three ways.
You can purchase two additional servos and use flaps for
landings. If you never intend to use flaps, you may glue the
flaps in the fully retracted position. If you want the option to
add flaps later you can install the control horns and fix them
in place using the supplied flap pushrod.
❏
1. To permanently fix the flaps in the retracted position,
glue the wing flap servo bay covers in place.
❏
2. Trim the covering from the leading edge of each flap.
Remove the covering from the trailing edge of the wing in
front of each flap. Trim the covering about 1/16" [1.6mm]
inside of the edge.
