6.
ADD THE SHEETING AND CAP STRIPS
Cut the sheeting to fit first then glue in place. Glue
on the 1/16
x
2-1/8
x
24 leading edge sheeting, the 1/16
x
7/8
x
24 trailing edge sheeting and the 1/16
x
3
x
15 center section
sheeting. Do not glue the sheeting to the cabane holders as
you will cut away this sheeting later. Cut cap strips from 1/16
x
3/16
x
36 balsa and glue them in place over the rib edges.
7 .
ADD 1/4 TRI STOCK BRACES
After the glue is dry, turn the wing over and pin it
down to the building board. Use 1/4
x
36 triangle stock and cut
pieces
to
fit along the length of the cabane holders as shown
on the plan. Glue this 1/4 tri to the sheeting and to the cabane
holder. Also cut tri stock to fit
on either side of the three center
.
ribs on top
of the cabane holders. Glue these braces in place.
\
8.
ADD THE REST OF THE SHEETING
Glue on the 1/16
x
2-1/8
x
24 leading edge sheeting,
the 1/16
x
7
/
8
x
24 trailing edge sheeting and the 1/16
x
3
x
1
5
center section sheeting. Glue on the 1/16
x
3/16 cap strips.
9.
ADD THE TRAILING EDGE
Add the tapered
3 / 8
x
1
x
24 balsa trailing edge stock
and the
3 / 8
x
1
x
6 tapered center trailing edge piece. Cut parts
to fit first and then glue them in place. Now cut the curve in the
center trailing edge as shown on the plan and in the photo.
5
Summary of Contents for Sportster Bipe 40
Page 25: ...MOUNT...
Page 26: ...HAYES AL 60...
Page 31: ...I Use trim MonoKote and these letters to create your trim scheme on your Sportster...
