12
Hook Up the Elevator and Rudder
❏
1. Mount the elevator and rudder servos as shown. (If your
servos do not fi t, the servo tray may be trimmed as necessary.)
Drill 1/16" [1.5mm] holes for the servo mounting screws and
mount the servos with the screws that came with them.
❏
2. Slide one of the small, plastic tubes onto one of the
pushrods. Make a slight bend 2" [50mm] from the back end
of the pushrod.
❏
3. Guide the pushrod down through and out one of the
slots in the boom – the bend in the wire will allow the end of
the wire to poke up through the slot.
❏
4. Straighten the pushrod by removing the bend.
❏
5. Prepare and install the other pushrod through the other
slot in the boom the same way – don’t forget to install the
small plastic tube fi rst!
Elevator
9/32" [7mm]
(2
nd
hole in Tactic
servo arm)
Rudder
7/16" [11mm]
(4
th
hole in Tactic
servo arm)
❏
6. Same as was done for the aileron servo arms, enlarge
the holes in the elevator and rudder servo arms with a
#55
(.052" [1.3mm]) drill. It may be necessary to trim the servo
arms, but only enough so they don’t interfere with the inside
of the fuselage when the arms are on the servos.
❏
7. Fit the pushrods into the holes in the servo arms
indicated in the previous illustration. Temporarily install the
servo arms to the servos.
