16
E. Cover the bullets with 3/16" [4.8mm] shrink tubing (not
included).
❏
10.
Remove the propeller from the motor before
connecting the ESC!
Then, connect the ESC to the motor
and your receiver and power up the radio so you can run the
motor. Make sure the motor is turning in the correct direction.
If not, simply swap any two of the wires between the ESC
and the motor.
❏
11. Mount the ESC to the side of the fuselage with double-
sided foam mounting tape. If necessary, the included lite-
ply wire holder may be glued into position to keep the motor
terminal wires from contacting the motor.
Final Assembly
❏
1. Install the receiver so it will be secure, somewhat
cushioned and so the antennas will be positioned according
to the manufacturer’s instructions. In this Tori, we taped one
of the antennas to the bottom of the fuselage before installing
the receiver, then fi t the receiver under the pushrod guide
brace with 1/4" RC foam under the receiver. A hole was
drilled in the fuselage side for a plastic guide tube (cut from a
tube from a spray can or similar – not included) for the other
antenna to achieve the 90° separation specifi ed for the Tactic
receiver. (Note that the antennas do not have to be outside
the fuselage, but doing it this way was quick and simple.)
❏
2. Trim the softer, “loop” side of the included adhesive-
back hook-and-loop material to fi t the battery, and then
attach to the battery.
