D 13. Install the aileron servo in the aileron servo tray.
Thread the nylon 6-32 torque rod connectors on the torque
rods until they are 3/4" from the wing sheeting.
D D 16 Thread a nylon clevis 13 turns onto the end of a
12" threaded pushrod. Attach the clevis to the control horn
on the top wing aileron.
D 14. Thread nylon clevises onto two 12" threaded
pushrods Connect the clevises to the torque rod connectors
and secure them with silicone retainers. Bend, cut and attach
the other end of the pushrods to the aileron servo with
faslinks, as described before.
D D 15. Attach both wings to the fuse Position the small
control horns on the TE of the ailerons, in line with the
struts. With the control horn base flush with the TE of the
aileron, mark the location of the mounting holes Drill a
3/32" hole at the marks Trim the control horn so that only
the bottom hole remains Mount the control horns on the
ailerons with the backing plate and 2-56 x 3/8" screws.
Note: The control horns go on the top of the aileron, on the
bottom wing and on the bottom of the aileron, on the
top wing.
D D 17. Set the ailerons on the top and bottom wings to
neutral. Mark the pushrod at the attachment hole in the
control horn.
D D 18. Remove the pushrod and make a "Z-bend" at
the mark.
42
