DC Inverter U-match Series Duct Type Unit
19
(4) Pass the unit hangers over the bolts installed to the ceiling and
install the unit with the special nut. See the following figure.
Hook
Screw
Nut
Nut
≤4
8m
m
I
3:1
I
3.2.1.2 Leveling
The water level test must be done after installing the indoor unit to
make the unit is horizontal, as shown below.
3.2.2 Outdoor Unit Installation
(1) If the outdoor unit is installed on a solid ground such as
concrete, use M10 screw bolts and nuts to secure the unit and
make sure the unit stands erect and level.
(2) Do not install it on top of the building.
(3) If it vibrates and causes noise, please add rubber cushion
between the outdoor unit and the installation base.
(4) When the outdoor unit is in heating or defrosting, it needs to
drain water. When installing the drain pipe, plug the
accompanied drainage connector to the drainage hole on the
chassis of the outdoor unit. Then connect a drain hose to the
drainage connector (If drainage connector is used, the outdoor
Summary of Contents for DC Inverter U-match Series
Page 65: ......