INSTALLATION INSTRUCTIONS
Models:
E2CORD-230V15A
E2CORD-230V20A
E2CORD-230V30A
E2CORD-265V15A
E2CORD-265V20A
E2CORD-265V30A
SAFETY PRECAUTIONS
–
Please read the following before installation.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
This mark indicates procedures which, if improperly performed, might lead to the death or serious injury of the user.
This mark indicates procedures which, if improperly performed, might possibly result in personal harm
to the user, or damage to property.
Notice is used to highlight suggestions which will result in enhanced installation, reliability and operation.
– Electrical shock hazard and/or unit operation and damage hazard
Failure to follow this warning could result in personal injury or death and/or unit operation and damage. Installing and servicing air conditioning equipment
can be hazardous due to system pressures and electrical components. Only trained and qualified personnel should install or service air conditioning
equipment. When working on air conditioning equipment, observe the precautions provided in literature, tags and labels attached to the unit.
1. Follow the National Electrical Code (NEC) or local codes and ordinances.
2. For personal safety, this unit
MUST BE
properly grounded.
3. Protective devices (fuses or circuit breakers) acceptable for unit installations are specified on the nameplate of each unit.
4.
DO NOT
use an extension cord with this unit.
WARNING
CAUTION
NOTICE
WARNING
Unit Model
ETAC2-07HC230VA-A
ETAC2-09HC230VA-A
ETAC2-12HC230VA-A
ETAC2-15HC230VA-A
ETAC2-07HP230VA-A
ETAC2-09HP230VA-A
ETAC2-12HP230VA-A
ETAC2-15HP230VA-A
ETAC2-07HC265VA-A
ETAC2-09HC265VA-A
ETAC2-12HC265VA-A
ETAC2-15HC265VA-A
ETAC2-07HP265VA-A
ETAC2-09HP265VA-A
ETAC2-12HP265VA-A
ETAC2-15HP265VA-A
POWER CONNECTION CHART
Electric Heater - Amp (KW)
20A (3.5KW)
230/208 VOLTS
E2CORD-
230V20A
265 VOLTS
E2CORD-
265V20A
15A (2.5KW)
E2CORD-
230V15A
E2CORD-
265V15A
30A (5.0KW)
Not Available
E2CORD-
230V30A
Not Available
E2CORD-
230V30A
Not Available
E2CORD-
265V30A
Not Available
E2CORD-
265V30A
* Using 30A on these units could result in damage to your unit.
* Only one power cord provided depending on kit ordered.
Screw (1)
265v Power Cord (1)
Wire Clamp (1)
Accessory Power Cord Assembly for
E-TAC II Packaged Terminal Air Conditioners
208/230v LCDI Power Cord (1)
*
*
