S2S KNX Gateway
12
Parameter “Power On Setting”:
This parameter is to set the status of air conditioner after being energized.
Select Previous Setting means it is under the status before the power failure;
select Preset mode means it will resume to the setting status after being
energized. Set the ON/OFF status under such parameter, set the temperature
(Temperature [16..30]
℃
), operating mode (Mode), fan speed.
Parameter “Disable Object”:
Setting of this parameter means whether to turn on the function of disable
object. When the value is 1, the function is activated, user can send the
command to select whether to shield the command via ETS; when the value is
0, the function is not available.
Parameter “Support 1Bit Up Down Set Mode”:
This parameter is to set if the + and – function of mode is available;
Parameter “Support 1Bit Up Down Fan Speed”:
This parameter is to set if the + and – function of fan speed is available;
Parameter “Lower limit Temp. of Cool energy saving[16..30]
℃
”:
This parameter is to set the lower limit temperature of energy-saving
cooling.
Parameter “Upper limit Temp. of Heat energy saving[16..30]
℃
”:
This parameter is to set the upper limit temperature of energy-saving
heating.
