S2S KNX Gateway
4
(4) Can directly connect to KNX EIB bus bar;
(5) Can directly connect to Gree IDU;
(6) Multiple controllable objects (including different types: bit, byte…)
(7) Support 4 preset scenes;
(8) Can be monitored via KNX bus bar, including status and error
information of air conditioner.
3 Introduction to Functions
3.1 Indicators
HBS indicator: if the communication between S2S KNX Gateway and the
unit is normal, the HBS indicator will be on constantly; if there is communication
error between S2S KNX Gateway and the unit, the indicator is off.
RUN indicator: if the S2S KNX Gateway works normally, RUN indicator
flashes.
Prog. indicator: when the indicator is on, it means the S2S KNX Gateway
is under programming status; when the indicator is off, it means the S2S KNX
Gateway quits programming status.
3.2 Functional Dial Codes
Setting area of S2S KNX Gateway DIP switch is located inside the product.
The first knob of functional dialer S1 is used for setting the master and
slave HBS equipment, after altering the setting of master and slave HBS
