Gree Mini-Floor Console A Series, Owner'S Manual

MINI-FLOOR CONSOLE A SERIES

OWNERS MANUAL - INDOOR UNIT

 |

 11

OPERATION OF REMOTE CONTROLLER (Continued)

OPERATION OF REMOTE CONTROLLER (Continued)

Under COOL or HEAT mode, press this button to turn to 
quick COOL or quick HEAT mode. “ “ icon is displayed 
on remote controller. Press this button again to exit 
turbo function and “ “ icon will disappear. This function 
will allow the unit to run at very high fan speed to reach 
the desired temperature.

• Press “ “ or “ “ button to increase or decrease the 

set temperature 1 °C(2°F). Hold “ “ or “ “ button for 2 
Sec, set temperature on remote controller will change 
quickly. Temperature indicator on indoor unit will 
change accordingly.

• When setting T-ON, T-OFF or CLOCK, press “ “ or “ “ 

button to adjust time. (Refer to CLOCK, T-ON, T-OFF 
buttons)

Press this button to select left & right swing angle.
Fan blowing angle can be selected circularly as below:

NOTE

• Press this button continuously more than 2s, the 

louver will swing back and forth from left to right, 
when you release the button, the louver will stop 
swinging at its present position.

• Under left and right swing mode, when the status 

is switched from off to  , pressing this button 
again for 2s and   status will switch to off status; 
pressing this button again for 2s, will change the 
swing status according to the sequence shown 
above.

• This function is not available for this unit

Press this button to select up & down swing angle. Fan 
angle can be selected circularly as below:

• Select  “ “, to select automatic fan circulation. 

Horizontal louver will automatically swing up & down 
at maximum angle.

• Select “

“, and fan modulation will stop at 

that fixed position. Horizontal louver will stop at the 
fixed position.

• Select “

“, will not modulate but blow at a fixed 

angle.

• Hold “ “ button more than 2s to set your required 

swing angle. When reaching your desired angle, 
release the button.

NOTE

• Pressing this button continuously for more than 

2s, the louver will swing back and forth from up to 
down, release the button, will stop the louver at the 
desired position.

• Under up and down swing mode, when the status is 

switched from off to  . Pressing this button again 
for more than 2s will turn off the   status. Pressing 
again within 2s, will change the swing status to the 
diagram above.

• T-ON button
  “T-ON” button will set the time for timer on. After 

pressing this button, “ “ icon disappears and the 
word “ON” on remote controller blinks. Press 

“ “ or “ “ button to adjust T-ON setting. After each 
pressing “ “ or “ “ button, T-ON setting will increase 
or decrease 1min. Hold “ “ or “ “ button, 2s longer 
and the time will change quickly until reaching your 
desired time. Press “T-ON” to confirm. The word 
“ON” will stop blinking. “ “ icon resumes displaying. 
Cancel T-ON: If T-ON is initiated, press “T-ON” button 
to cancel it.

• T-OFF button
  “T-OFF” button will set the time for timer off. After 

pressing this button, “ “ icon disappears and the 
word “OFF” on remote controller blinks. Press “ “ or 
“ “ button to adjust T-OFF setting. After each press 
of the “ “ or “ “ button, T-OFF setting will increase or 
decrease 1 min. Holding the “ “ or “ “ button for more 
than 2s the time will change quickly until reaching 
your desired time. Press “T-OFF” and “OFF” will 
stop blinking. “ “ icon resumes displaying. To cancel 
T-OFF when it’s on, “T-OFF” button to cancel it.