FAN button
3
Pressing this button can set fan speed circularly as: auto (AUTO), low( ), medium
( ), high( ).
Auto
Introduction for buttons on remote controller
Note:
● For preventing cold ai
r, after starting up heating mode, indoor unit will delay 1~5
minutes to blow air (actual delay time is depend on indoor ambient temperature).
● Set temperature range from remote controller: 16~30
℃
(61-86°F);
Fan speed: auto, low speed, low-medium speed,medium speed, medium-high
speed,high speed.
TURBO button
4
Under COOL or HEAT mode, press this button to turn to quick COOL or quick
HEAT mode. " " icon is displayed on remote controller. Press this button again
to exit turbo function and " " icon will disappear.
If start this function, the unit will run at
super-high
fan speed to cool or heat quickly
so that the ambient temp. approachs the preset temp. as soon as possible.
▲
▲/ button
5
● Press "▲" or " " button once increase or decrease set temperature 1
℃
(°F).
Holding "▲" or " " button, 2s lat
er, set temperature on remote controller will
change quickly
. On releasing button after setting is finished, temperature indica-
tor on indoor unit will change accordingly.
▲
▲
● It’s Low fan speed under Dry mode.
This function indicates that moisture on e
v
aporator of indoor unit will be blowed
after the unit is stopped to avoid mould.
Having set X-
FAN function on: After turning of
f the unit by pressing ON/OFF
button indoor fan will continue running for a few minutes. at low speed. In this
period, Hold fan speed button for
2
s to stop indoor fan directly.
Having set X-
FAN function off: After turning of
f the unit by pressing ON/OFF
button, the complete unit will be off directly.
X-
FAN function Hold fan speed button for
2
s in COOL or
D
RY mode, the icon “ ” is
displayed and the indoor fan will continue operation for a few minutes in order to dry
the indoor unit e
v
en
though you have turned o
ff the unit.
After energization, X-FAN
OFF is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
●
●
●
● Under
AUTO speed, air conditioner will select proper fan speed automatically
according to ex-factory setting.
Note:
3
