15
1-855-GRN-RYDE
(1-855-476-7933)
www.greenlightcycle.com
USER MANUAL - URBAN RYDER™
URBAN RYDER™ OPERATION: SYSTEM
Display Units
Press the Up or Down Arrow to choose between
Imperial or Metric
display units. Press the Mode button to confirm the
setting.
Wheel Diameter Setting
Press the Up or Down Arrow to choose a corresponding wheel diameter to ensure the accurate display of speed and
distance on the LCD. The Urban Ryder™ wheel size is 26 inches. Press the Mode button to confirm the setting.
Backlight Brightness
Press the Up or Down Arrow to modify the backlight brightness. You can choose from levels 1 to 3. Level 1 is the minimum
brightness and uses the least power from the battery. Level 3 is the brightest and will use more power from the battery.
Press the Mode button to confirm the setting.
Exit Settings
When in a setting mode, press the Mode button within 2 seconds of making your choice to confirm. Press and hold the
Mode button for more than 2 seconds to save the current settings and exit the setting interface.
The King Meter® is now set.
Fig. 10.2 Hold down “MODE”
Button for 2
Seconds
10. Normal Operation of the E-Bike
Before you turn on the battery power to ride the bike, sit on the bike seat and
assume a comfortable position to ride forward.
With the key in the “ON” position, press the Mode button and the display will
illuminate. The motor is now powered. Keep one hand brake depressed after
turning on the King Meter® until you are ready to ride forward.
When the King Meter® is turned on (display illuminated), holding or pressing
the Mode button again will turn the power to the bike motor off. If no controls
are pressed for approximately 5 to 7 minutes and the bike is not in motion, the
King Meter® will power off.
Power OFF
In the power “OFF” state, the King Meter® uses minimal power to keep the clock running. It is advisable to turn the key on
the battery to the “OFF” position to conserve energy and keep your bike and the people around you safe.
Speed Display
When the King Meter® illuminates, the display will automatically show the current speed. By pressing and holding the Up
Arrow for 2 seconds, the display will show the average (AVG) speed during this ride. Press and hold the Up Arrow again and
the display will change to show the maximum (MAX) speed during this ride. Repeat to show current speed again.
Urban Ryder™ Operation: System - System and Battery Power “ON/OFF”
