INSTALLATION
Ensure electricity is switched off at the mains before installing or maintaining this lantern.
THIS FITTING MUST BE INSTALLED IN ACCORDANCE WITH
CURRENT IEE WIRING REGULATIONS AND BUILDING
REGULATIONS (PART P). FOR YOUR OWN SAFETY, THIS
LANTERN MUST BE EARTHED. UNDER NO CIRCUMSTANCES SHOULD
THIS METAL FITTING BE WIRED TO AN UNEARTHED
CIRCUIT. CONTACT A QUALIFIED ELECTRICIAN TO
INSTALL A SUITABLE EARTH FACILITY.
IF YOU ARE IN ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
Please note: For new installations, check for any electrical cables or pipe work
(gas/water) in the vicinity of the intended mounting point for the product, before
proceeding with the installation.
1. Remove the junction box by removing the dome nuts,
sealing washers and metal washers. Take care of the
weather proof gasket (FIGURE 1).
FIGURE 1
4 X3
1 X2
3 X2
2 X3
5
