INSTALLATION - continued
2. Use the junction box as a template
and mark the positions for the two
deep and insert masonry plugs so they
(FIGURE 2).
3. Pierce a hole in the grommet and
push the mains cable through allowing
enough cable for connection to the
terminal block (FIGURE 2).
4. Push the hex screws through the
back of the junction box so they
protrude inside the box (FIGURE 2).
Fix the junction box to the mounting
(FIGURE 2).
6. Connect the mains supply cable to the terminal block using the following
colour code for the wiring (FIGURE 3):
Connect the wire coloured Brown or Red (Live) to the corresponding Brown
wire in the terminal block, or the terminal marked L.
Connect the wire coloured Green/Yellow or Green (Earth) to the corresponding
Green/Yellow wire in the terminal block, or the terminal marked E or .
Connect the wire coloured Blue or Black (Neutral) to the corresponding
Blue wire in the terminal block, or the terminal marked N.
Clip the terminal block on the junction box.
REMEMBER: THIS FITTING MUST BE EARTHED.
P-LUX UNIT
FIGURE 2
FIGURE 3
1
2 X2
L
N
