Install Smart Power Strip
The smart power strip allows the user to track electricity consumption of group
home appliances in the same area and protect it against surge and voltage spikes.
1. Plug in the smart power strip to a powered AC outlet.
2. Plug in the appliances into the smart power strip outlets.
3. The Energy Saver outlets on the power strip can be manually turned ON/OFF
by pressing the “Manual ON/OFF” button on the power strip. You may also
control the energy saver outlets remotely by using the energy monitor (see
the operation instruction).
4. Perform initial energy monitor and smart power strip pair up (see the
operation instruction).
GREEN POWERLINK On-Line Energy Management Solution V1.0
6
GREEN POWERLINK On-Line Energy Management Solution V1.0
7
Install CT Smart Meter in the circuit breaker panel
The CT smart meter allows the user to measure entire electricity
powerconsumption from electrical panel.
Caution
Your safety is very important to us. Please read these cautions
regarding the installation of your CT Smart Meter.
＊
Electrical panel contains live electrical wires and components even
when the main circuit breaker has been switched off. Do not attempt
any installation unless you are familiar where these electrified areas
are.
＊
Any work on or near electrical panel could induce danger or fatal
electrical shock. It is highly recommended that all work should be
done only by qualified electricians or certified electrical specialist.
Prepare the electrical circuit breaker
WARNING:
＊
Before you start, you must turn off all power in the electrical circuit
breaker by turning off the main breaker or main switch.
＊
Some wires and components could still be live even when the main
breaker or switch is turned off. Please indentify these wires and
components before installation and pay attention to these areas at all
time.
1. Turn off all power by turning off the main breaker or main switch.
2. Remove the cover of electricity circuit breaker panel.
Manual ON/OFF”
button
PROTECTED LED LIGHT
This LED light illuminates
to indicate that the surge
protection is active and
protecting equipments
from power surges.
GROUNDED LED LIGHT
This LED light illuminates
to indicate that the surge
protector is plugged into a
properly grounded outlet.
ALWAYS ON OUTLETS
are also available for
devices which are always
kept on and need
continuous power.
!
