5.FAQ
What should I do if I cannot find the LiPod connection after powering on the system?
In general, in 1 minute after powering on the LiPod system, a Wi-Fi connection called ‘LiPod’ should be available. If not, try refreshing your
phone or tablet. If the problem is not resolved after 5 minutes, please power off the system, reboot the computer, and then search for Wi-Fi
networks again.
Why I cannot see any point cloud displayed when I click on the Start button as the computer
is started and connected to Wifi?
Please check: (1) Check the device data acquisition status. Only a recording state displays point clouds (2) if the mobile device has been
connected to another device, please clear browsing data.
Why can't the power be turned on after booting, and the green button does not light up?
Please check
：（
1
）
The battery is sufficient
；（
2
）
The battery cable is connected.
To avoid battery damage, do not overdischarge the battery.
It is recommended to stop the collection operation when the power is below 30%, replace the battery or fully charge the battery.
What should I do when LiPod Wi-Fi is found but the UI device cannot connect to it?
If the device is an iPad or iPhone, please refer to Apple’s instructions for resetting the network settings, or follow these steps:
If the device used is an Android device, please follow these steps to reset and reconnect to the LiPod Wi-Fi
22
