www.GreenSeriesFitness.com
©June 2015
Call Toll free at 800-269-7130
CIR-TM6000DC-G Revision 1.1
14
UNPACKING & ASSEMBLY
Step 5
: Assembly console mast with console set.
NOTICE: Two people are required for the following steps or damage may occur to wire
harness when installing main display housing to front tubes.
1).Connect the upper console wire from console to lower console wire on the right console mast.
2). Push down in the right tube the wire and connectors.
3). Set the whole console set on the console mast. Make sure to align bolt holes with the screw holes.
4). Fasten by hand four (4) 8mm x 15mm bolts, two (2) 8mm washers and two (2) 8mm curve washers
on left console mast four (4) 8mm x 15mm bolts, two (2) 8mm flat washers and two (2) 8mm curve
washers on right console mast front and rear.
5) At this time now, tighten all of the bolts using a 5mm Allen wrench.
6) Repeat tightening all bolts on lower frame from
Step 2.
8mm Flat Washer
(4 each)
*Inside Only
8mm x 15mm
(8 each)
8mm Curve Washer
(4 each)
*Front & Back Only
Upper console wire
Lower console wire