66
PERIODIC MAINTENANCE
•
Perform regular inspections on the machine to ensure efficient operation of the machine.
•
For thorough maintenance, we recommend that you take the machine to your Technical Service.
•
Always use original spare parts in order to obtain an adequate performance of the product and avoid damages
and risks to machine and/or user.
Carry out the following maintenance work as per the indicated frequency in the following table:
MAINTENANCE
EVERY 2 FUEL REFILLS
EVERY 10 FUEL
REFILLS
ONCE A YEAR
Air Filter
•
Fuel Filter
•
Sparkplug
•
AIR FILTER
Check and clean dirt from the air filter as otherwise this will reduce machine performance.
If you notice filter damage or any abnormal condition, replace it with a new one.
To clean the filter:
1. Remove the filter protection cap.
2. Remove the filter.
3. Dust/soil can be cleaned on the outside of the filter by shaking it off against a hard surface.
4. Clean the filter with soapy water.
5. Rinse the filter with plenty of clean water.
6. Allow the filter to dry.
7. Once dry moisten it with 2 drops of oil (Do not wet it too much or the engine will not start)
8. Install the filter in the machine.
9. Put the protective cap on.
NOTE:
The engine must never run without the air filter installed.
FUEL FILTER
•
The fuel tank is equipped with a filter. It is located at the end of the fuel suction pipe and can be removed with
the help of a hook-shaped wire.
•
Check the fuel filter periodically. Do not allow dirt to enter the fuel tank to prevent the filter from getting dirty.
A dirty filter will make it more difficult to start the engine and will cause operation irregularities or stoppage of
the motor.
•
Check the fuel. If you notice dirt, replace it.
•
If the inside of the fuel tank is dirty you can clean it with gasoline.
SPARK PLUG CHECK
The most common problems when starting a machine are produced by a dirty spark plug or in
poor condition. Clean the spark plug and check it regularly. Check that the distance between
electrodes is correct (0.6 - 0.7mm).
ENGINE VENTILATION CONDUCTS
Remove dirt from the ventilation conducts, in order to avoid damage to the engine and/or a
possible fire.
Summary of Contents for 1000086
Page 87: ......
Page 88: ...www greencut es Manual revisado en marzo de 2020...
