59
EN
TROUBLESHOOTING
Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance so that the machine continues to function properly. The table includes some of the most common
problems, their possible causes and solutions.
PROBLEM
POSSIBLE CAUSE
SOLUTION
The engine
fails to start
• Fuel tank is empty
• Clogged fuel filter
• Spark plug wire disconnected
• Defective spark plug
• Defective spark plug
• Fill the fuel tank with the correct fuel
• Clean the fuel tank
• Connect the wire to the spark plug
• Clean the spark plug
• Replace the spark plug
Power loss;
Irregular
operation
• Loose spark plug wire
• The unit continues to operate with the
choke
• Fuel line clogged
• The fuel tank is almost empty
• Carburettor requires a reset
• Dirty/clogged air filter
• Fuel tank dirty
• Tighten the spark plug connection
• Move choke lever to normal state
• Clean the fuel lines
• Fill the fuel tank
• Consult your local distributor
• Clean or replace the air filter
• Clean the fuel tank
The motor
overheats
• Low level of engine oil
• Debris around the engine
• Fill with the correct level of oil
• Turn off the unit and clean around the
motor
The unit
vibrates
• Loose motor support plate
• Damaged blades
• Debris stuck on the blades
• Uneven surface
• Tighten the support plate
• Check the blades and replace them if
necessary
• Check the blades and remove any debris
• Place the unit on a flat surface
The unit does
not discharge
• The shredder is blocked
• Disconnect the spark plug wire and then
clean the shredder
• Add dry material or a mixture of different
materials
• Reduce the volume of material in the
conduit
• Check that the blades are not broken
The unit does
not work
• The unit takes longer to process the
material
• Check and replace the blades
• Replace or sharpen the blades
• Check that the belt is properly tensed
NOTE:
If you can not solve the problem, contact the Official Technical Service.
Summary of Contents for GE8010E
Page 62: ...62...
Page 63: ...63 EN...
Page 64: ...www greencut es Manual revisado en mayo de 2018...