51
EN
MAINTENANCE
Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION
: Make sure the machine is completely turned off before performing any maintenance
or repairs. This will eliminate any potential risk.
The machine is set at the factory. Do not make unnecessary adjustments, adjust only when necessary
due to normal wear.
CLEANING GUIDELINES
ATTENTION
: Do not use solvents, chemicals or abrasives when cleaning the machine, as some
surfaces may be damaged.
•
Use gloves or appropriate tools for cleaning. Do not do it with unprotected hands.
•
Clean the machine after each use to ensure best performance and durability.
•
It is recommended that the machine be raised when checking or maintaining the lower part of the cover, avoiding
tilting it so that fuel or oil does not spill.
•
Use a slightly damp cloth, water and a mild detergent for cleaning.
•
Use a brush for the parts or pieces that are difficult to access.
•
Make sure that all ventilation slots designed for heat dispersion are clean and free from obstructions or residues.
•
Remove grass clippings, dirt, etc. from the underside of the cover and blades (the wash function on some models
makes this task easier).
•
It is recommended to put a little oil on the blades after each use to avoid corrosion.
•
Make sure all hoppers and covers are clean and unobstructed.
•
Make sure all cables, levers, switches, etc. are clean and working as they should and without problems.
TROUBLESHOOTING
The table includes some of the most common problems, their causes and remedies.
PROBLEM
POSSIBLE CAUSE
SOLUTION
The thread does
not advance
when it hits the
spool adjuster
• The thread is attached to itself
• Not enough thread on the reel
• The thread is too short
• Lubricate with a silicone spray
• Install more thread
• Pull the nylon thread while alternately
pressing and releasing the spool adjuster
The semi-
automatic reel
does not turn
• Wrapped or accumulated grass around
the head
• Clean the affected parts of the machine
The grass is
wound onto the
hitch shaft and
the brushcutter
head
• Mow the tall grass at ground level
• Mow the tall grass from top to bottom
Summary of Contents for GGT1200C
Page 67: ...67 FR...
Page 68: ...www greencut tools com Manual revisado en junio de 2021...
