54
4. Clean the 3 holes in the suction pipe, if blocked, with the cleaning needle supplied. If these holes are partially
blocked, the result will be uneven and inconsistent spraying.
5. Thoroughly clean the suction pipe with water or solvent before reassembling.
6. Replace the suction tube and fill the container with solvent or water.
7. Screw the container into place. Turn on the device and spray the solvent or water into a container.
8. Repeat the above procedure until water or clear solvent comes out of the nozzle.
NOTE:
Only use a solvent with a flash point above 21°C.
9. Turn off the device.
10. Then empty the container completely. Always keep the closure of the container free of liner material and
check for damage.
11. If the gun casing requires cleaning, immerse a cloth in the solvent or water, making sure the cloth does not
leak, clean the outside of the spray gun.
12. Unscrew the nut from the air cap. Remove the air cap. Clean the air cap and nozzle with a brush and solvent
or water.
13. Before storing the Mobile Paint Unit, make sure it is completely dry. This will minimize the accumulation of
waste for the next use.
CLEANING THE PISTON OF THE PISTOL
If the paint has dried in the paint head or the spray gun has had a lot of use, removing, cleaning or replacing the
plunger can restore the original performance of the spray gun.
To clean the plunger:
1. Remove the air hose from the spray gun. Carefully unscrew the piston from the pistol with an 8 mm sleeve
(not supplied) and remove it from the back of the pistol.
2. Clean plunger and spray gun assembly, remove paint with clear solvent or water.
3. After cleaning, reassemble the plunger in the correct order and place it on the back of the spray gun.
1
3
4
