3
Lighted Switch Notes
ControlKeeper® TouchScreen Logic Board
Lighted Switch Notes
1. You must use lighted switches that have been approved
for use with the ControlKeeper T system.
2. The panel’s onboard power supply can support up to
75 LED lighted switches in a CKT16 enclosure, 45 LED
lighted switches in a CKT32 enclosure and 30 LED
lighted switches in a CKT48 enclosure. Please contact
technical support if it is necessary to power additional
switches beyond the numbers listed above. No more
than 6 LEDs may be run per input channel.
3. The panel’s onboard power supply can support up to 38
incandescent lighted switches in a CKT16 enclosure,
23 incandescent lighted switches in a CKT32 enclosure
and 15 incandescent lighted switches in a CKT48
enclosure. Please contact technical support if it is
necessary to power additional switches beyond the
numbers listed above. No more than 3 incandescent
bulbs may be run per input channel.
4. Please note that these figures may decrease if motion
sensors, photocells or digital switches are being used
with the controller. In addition, if switch types are
mixed (incandescent and LED being used on the same
controller), these figures will change. Please contact
technical support with the numbers and types of inputs
you are using to determine if the controller will be able
to support them without overloading the power supply.
Lighted Switch Wiring Detail
Contact Input Photosensor and Greengate
Sensor Notes
It is possible to use a contact input photosensor and
Greengate motion sensors in conjunction with the lighting
control system. The ControlKeeper T enclosures are capable
of powering a number of these devices. Please refer
to the chart below for details on how many devices the
transformer can support.
Please contact technical support if it is necessary to power
additional sensors beyond the numbers listed above.
These figures do not account for additional devices such as
lighted switches or digital switches being used. If using a
combination of devices, please contact technical support for
precise limits on the number of devices the logic panel can
power.
Photocell and Motion Sensor Wiring
Digital Switch Wiring
ControlKeeper T panels are capable of supporting a number
of digital switch device stations and 1 GDS-I gateway device
(the number the controller is able to support is dependent
on the number of other low voltage devices wired that
require power from our logic board. Please contact technical
support for exact details of how many devices your logic
board can power.) Refer to the chart below for the number
of digital switch device stations based on panel size. Digital
switch cable type should be Eaton’s Cooper LC Cable,
Belden 1502R (non-plenum), or Belden 1502P (plenum).
For best network performance, one of the suggested
cables should be used. If the specified cable is not
used and communications problems occur that require
troubleshooting assistance, additional charges for support
may be assessed.
Enclosure
Size
CKT 16
CKT 32
150
90
60
36
75
45
75
45
Greengate
PIR Sensor
Greengate
Dual-Technology
Sensor
Greengate
Ultrasonic
Sensor
PPS-4
Indoor
Photosensor
15
9
CKT 48
90
24
30
30
6
PPS-5
Outdoor
Photosensor
CKT16
32 Devices
Including a GDS-I
CKT32
18 Devices
Including a GDS-I
CKT48
12 Devices
Including a GDS-I
