C . TAPInG GLASS BArS WITh FoAM
Tape all the aluminum Glass Bars with 1/8” foam tape . The curved glass end bars tape on one
side only . All other Glass Bars tape on both sides . Take a roll of tape and start at one end and
press on the bar .
Make sure that the aluminum is dry.
Taping it at this time, you can still move
all the pieces in the shed or undercover if it is raining .) Slowly roll down the tape toward
the outer edge and press it down at the same time .
(See pictures below)
Be careful because
sometimes the edge of the paper is quite sharp . Do not remove the paper until later .
NOTE:
Do not tape the place where the Glass Bar is notched out.
When all bars are completed, including the end walls, go to Step #1 of the aluminum frame
installation on the next page .
– 12 –
p r i d e o f t h e p a c i f i c S e r i e S c U r V e d G L a S S L e a N t o M o d e L • G r e e N h o U S e i N S t r U c t i o N S
Do
NOT
put foam tape along the
End Bars
.
The glass slides under the lip and needs to be sealed
when the greenhouse is finished
